LSD Bearing G3

(No reviews yet) Write a Review
2.00 LBS
Calculated at Checkout

When installing an LSD, it's much easier to replace the carrier bearings than try to get the old ones off. This is the best bearing you can buy for this application! Fits all Gen 3 cars. F56, F57, Possibly others. We have both Timken and Koyo bearings in stock for this application

Sold as a pair as shown.

Install Note: When installing, put the LSD in the freezer for a few hours and warm the bearing a bit (heat vent, or hands, no open flame). Do not get it too hot to touch. Then tap it on with a hammer making sure to hit the inner race. Make sure it's seated in place, then do the other side. Once both sides are on, allow the LSD to come to room temperature, then install. You now can spin both wheels! Best quality made in the USA bearing that you can buy!